Please read all instructions before proceeding.
When moving unit make sure you have a lifting partner as the laser system is over 50lbs.
Place the Galvo unit at the edge of a table with the black rail accessible from the bottom.
With the lens aperture facing downwards, align the wheels on the scan head to the black rail.
Slide the scanhead up and hold so it's just below the threaded Z-axis rod.
Power on the main body, press HOME LASER in the tools menu of the touchscreen. Hold the scanhead, being careful of moving parts, and allow it to bite the rod and raise from it's held position.
Press HOME LASER again until the laser head reaches the top and stops.
Near the bottom of the black railing, on the inner side where the rear of the scanhead is mounted, find the spot adjacent to the end of the threaded Z-axis bolt. Using the T-Bolt that came with your Galvo, install it inside that spot of the railing so the scanhead cannot lower below the Z-axis or fall off.
Still having Issues?
Please create a Support Ticket by using the button below or sending an e-mail to support@fslaser.com stating you've done all previous troubleshooting steps.
- When submitting via an e-mail you may attach any pictures, videos and project files needed for support to see.
- When submitting a ticket using the button below please either respond to the automated generated email stating we have received the ticket with your pictures, videos and project files or upload these to a Google Drive or Dropbox folder and include this link within the support ticket "Your Issue" dialog upon creation.