If your Z-Table isn't square and sits higher on one side/corner than the other you will need to adjust the table so it is flush on each side. You can watch the video below or use the attached guide for help.
Guide is for older Pro Series 20 and 24 units but steps will be similar. See link below.
Still having Issues?
Please create a Support Ticket by using the button below or sending an e-mail to support@fslaser.com stating you've done all previous troubleshooting steps.
- When submitting via an e-mail you may attach any pictures, videos and project files needed for support to see.
- When submitting a ticket using the button below please either respond to the automated generated email stating we have received the ticket with your pictures, videos and project files or upload these to a Google Drive or Dropbox folder and include this link within the support ticket "Your Issue" dialog upon creation.