Fiber Galvo/ MOPA Initial Setup

The following article is to help customers unbox their machines and perform the initial setup.

Unboxing:

1. 1. Prepare Work Space: You will need an open and level work space to place your laser cutter. A sturdy table with enough room for the machine is recommended. Be sure the table is free of clutter and can support a minimum of 400lbs (the machine itself weighs over 100 lbs).
   2. Place Box: Place your box on or near your table before opening it, using either a pair of scissors or a box cutter.

1. 3. Remove the Top Layer of Foam.

       

   4. Remove the stage base, power cord, and accessories from the packaging.

1. 5. Remove the Second Layer of Foam.

       

   6. Remove the Foam under the main unit.

7. Remove the Main Unit, Z-stage and Isolator from the Foam.

Initial Setup:

1. Secure the stage to the base using the m6 screws.

2. Slid the isolator into position and screw in place using the m5 screws.

3.  Grab Loom 1 connect the VGA cable to the back of the scanhead and the Type C cable to the camerahead. Then grab Loom 2, connect the 3 pin cable to the cable hanging near the motor and the other into the motor.

4. Place the machine cover over the laser head assembly and secure it in place.

Still having Issues?

Please create a Support Ticket by using the button below or sending an e-mail to [e-mail] stating you've done all previous troubleshooting steps.

• When submitting via an e-mail you may attach any pictures, videos and project files needed for support to see.
• When submitting a ticket using the button below please either respond to the automated generated email stating we have received the ticket with your pictures, videos and project files or upload these to a Google Drive or Dropbox folder and include this link within the support ticket "Your Issue" dialog upon creation.